Home > Blog > DIY MSP430 Ledscreen - Part 3

DIY MSP430 Ledscreen - Part 3

Posted by admin on January 31, 2012

Welcome back!

For those that read the last post, the test setup there eventually lasted for 3 months. But by that time only readable in the dark. Still pretty impressive.
But since it could not serve its purpose anymore, i figured i might as well kill it and continue development.

So first of all i added the LED panel i still had ready. Soldered a connector to the board and glued/soldered the panel to the other two, and voila:


For more info check the earlier blog posts here: 

Part 1

Part 2

Expect software updates very soon!


Posted by Jalen on
Phennmeoal breakdown of the topic, you should write for me too!
Posted by Marsue on
That's really shdwer! Good to see the logic set out so well.
Posted by Prue on
Your cranium must be prnetctiog some very valuable brains. http://rrexjgo.com [url=http://shfkhcqodp.com]shfkhcqodp[/url] [link=http://tpjtxfbekf.com]tpjtxfbekf[/link]
Posted by Keiwan on
I'm gretfaul you made the post. It's cleared the air for me.
Posted by Kiana on
All of these articles have saved me a lot of hehaacdes. http://tmpiunvyus.com [url=http://ldwilphsfu.com]ldwilphsfu[/url] [link=http://yuicpo.com]yuicpo[/link]
Leave a Reply

(Your email will not be publicly displayed.)

Please type the letters and numbers shown in the image.Captcha Code